Fusion 360 Internals: Trying to re-invent Fusion’s GUI (and failing)

Fusion 360 Internals: Trying to re-invent Fusion’s GUI (and failing)(whynot.fail)

4 points by ttouch 3 years ago | 2 comments

BMc2020 3 years ago |

If you hate F360, try DesignSpark Mechanical instead.

ttouch 3 years ago | |

It seems to be too simplistic. Just sketch & pull. No Surface/Mesh modeling, no advanced mirroring/etc. tools and no CAM (I can use something else for CAM but would be nice to have) And most of all: it doesn't run in wine

BMc2020 3 years ago |

If you hate F360, try DesignSpark Mechanical instead.

ttouch 3 years ago | |

It seems to be too simplistic. Just sketch & pull. No Surface/Mesh modeling, no advanced mirroring/etc. tools and no CAM (I can use something else for CAM but would be nice to have) And most of all: it doesn't run in wine