I electrified my push scooter with a power drill(eddieabbondanz.io) |
I electrified my push scooter with a power drill(eddieabbondanz.io) |
Immediately opened it and laughed out loud. Perfect execution, no notes.
> inability to bank to the right side is perfect.
The contrast between the 3D scanning and bolting a power drill to the side was fun.
Somehow I'd suspect that it won't last all that long...
It's brushless so brush wear isn't a problem, but these motors are air-cooled and will actually be cooler at high speed, low-demand. Lugging it up a hill would be a worst case.
But when the wipers in my car are set to intermittent, they are off most of time and ocassionally off.
Not very well. It will work as long as the power demand is below the point it starts hitting, and then just stall with the tires absorbing all the impact hits once it reaches that point.
https://en.wikipedia.org/wiki/Acrylonitrile_styrene_acrylate
He would see him leaning over and pulling the trigger get an electric assist on the uphill section of the commute.
Watch out for the gear change, may end up in hammer action.
it would have made more sense to just mount the motor and the planetary, but I think the planetary is important here.
I'm not sure where you are if you're seeing politicians turning left though.